Preparing Parts For Local Case-hardening





At the works of the Dayton Engineering Laboratories Company, Dayton,

Ohio, they have a large quantity of small shafts, Fig. 40, that

are to be case-hardened at A while the ends B and C are to

be left soft. Formerly, the part A was brush-coated with melted

paraffin but, as there were many shafts, this was tedious and great

care was necessary to avoid getting paraffin where it was not wanted.






To insure uniform coating the device shown in Fig. 41 was made.

Melted paraffin is poured in the well A and kept liquid by setting

the device on a hot plate, the paraffin being kept high enough

to touch the bottoms of the rollers. The shaft to be coated is

laid between the rollers with one end against the gage B, when

a turn or two of the crank C will cause it to be evenly coated.





Plant For Forging Rifle Barrels Preventing Carburizing By Copper-plating facebooktwittergoogle_plusredditpinterestlinkedinmail

Feedback